Reset Nck Data For The Simulation - Siemens SINUMERIK 840D sl Commissioning Manual

Simulation and simultaneous recording

9.3 Reset NCK data for the simulation

9.3 Reset NCK data for the simulation
If an alarm, designated with the Power On symbol occurs during simulation, then you must
reset the simulation and then reload again.
Procedure
Note
If you read-in an archive into the NCK, the general reset is automatically initiated.
9.4 Configuring the simultaneous recording
Configuring the simultaneous recording
114
1. Select the "Start-up" operating area.
2. Press the "HMI" softkey.
3. Press the ">>" and "Simulation general reset" softkeys.
The "NOTICE! Power On Reset" window is opened and you receive a
confirmation prompt: "Do you really want to completely initialize the
simulation again?"
4. Press the "OK" softkey.
A general reset of the simulation is initiated with a complete data
alignment with the real NCK.
Software option
For the "Simultaneous recording" function, you require the option:
"Simultaneous recording (real-time simulation)".
Software option
You require the "ShopMill/ShopTurn" option to display the tailstock
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
SINUMERIK Operate (IM9)