Measuring In Jog Mode - Siemens SINUMERIK 840D sl Commissioning Manual

22.8.3

Measuring in JOG mode

Preconditions
You have already made the settings from the previous section "Measuring cycles and
measurement functions, general (Page 531)".
Workpiece measurement
For milling:
● The probe has been inserted in the tool spindle.
● The probe has been selected in the tool list as type 7xx (probe).
● The probe is activated as tool in the current NC channel.
Tool measurement
To measure tools, an appropriate probe must be located in the machine space so that this
can be reliably and safely reached with a tool in the spindle.
The following tool types are supported with measure tool:
● Milling technology: Tool types 1xx and 2xx
● Turning technology: Tool type 5xx, 1xx, 2xx
For the specified tool types, the tool lengths and the tool radii can be measured.
Setting general data
SD54782 $SNS_J_MEA_FUNCTION_MASK_TOOL
Bit 2 = 1
Bit 3 = 1
Bit 10 = 1
Bit 11 = 1
MD51784 $MNS_J_MEA_T_PROBE_APPR_AX_DIR [i]
Measuring in JOG: Approach direction in the plane to the tool probe
-2
-1
0
1
2
SINUMERIK Operate (IM9)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
Activates the "Enable automatic tool measuring" function.
Selects the tool probe calibration data field, enable.
Selects the single cutting edge measurement (tooth breakage check).
Selects spindle reversal when calibrating in the plane
Negative direction, 2nd measuring axis
Negative direction, 1st measuring axis (default setting)
Positive direction, 1st measuring axis
Positive direction, 2nd measuring axis
Configuring cycles
22.8 Measuring cycles and functions
Settings for the input screen, measuring
in JOG, tool measurement.
537