Siemens SINUMERIK 840D sl Commissioning Manual page 768

"Custom" operating area
8.2 How to configure the "Custom" softkey
8.2 How to configure the "Custom" softkey
Configuring the softkey for the "Custom" operating area
The labeling and position of the softkey for the "Custom" operating area are configured in the
slamconfig.ini file.
The following options are available for configuring the start softkey:
1. To replace a softkey label with a language-dependent text, the following must be entered
in the [Custom] section:
TextId=MY_TEXT_ID
TextFile=mytextfile
TextContext=mycontext
2. To replace a softkey label with a language-neutral text, the following must be entered in
the [Custom] section:
TextId=HELLO
TextFile=<empty>
TextContext=<empty>
In this example, the softkey for the "Custom" operating area displays the text "HELLO" for
every language.
150
In this example, the softkey shows the language-dependent text which was saved with
the text ID "MY_TEXT_ID" in text file mytextfile_xxx.qm under "MyContext" (xxx stands for
language code).
SINUMERIK Integrate Run MyScreens (BE2)
Programming Manual, 03/2013, 6FC5397-1DP40-3BA1