General settings
6.11 Program selection
68
6.
Place the cursor on the desired program and press the "OK" softkey.
The selected program is inserted in the first line of the list together with
its path.
- OR -
Enter the program name directly in the list.
If you are making entries manually, check that the path is correct (e.g.
//NC/WKS.DIR/MEINPROGRAMM.WPD/MEINPROGRAMM.MPF).
If required, the extension (.MPF) is added.
Note:
A syntax check is not performed.
With workpieces, make sure that there is a main program or a job list
with the same name in the workpiece itself.
7.
To remove a program from the list, place the cursor on the appropriate
line and press the "Delete" softkey.
- OR -
To delete all programs from the program list, press the "Delete all"
softkey.
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
SINUMERIK Operate (IM9)