Measuring Tools In Milling - Siemens SINUMERIK 840D sl Commissioning Manual

Configuring cycles
22.8 Measuring cycles and functions
22.8.3.2

Measuring tools in milling

Measuring feedrate for tool measurement in JOG and AUTOMATIC
SD55628 $SCS_MEA_TP_FEED_MEASURE
= 300
Note
Measuring feedrate for tool measuring
All measuring cycles use the value saved in SD54636 or SD54651 as the measuring
feedrate after the tool probe has been calibrated. A different measuring feedrate can be
assigned for each calibration field [n].
When calibrating the probe, either the measuring feedrate from
SD55628 SCS_MEA_TP_FEED_MEASURE is used, or the measuring feedrate can be
overwritten in the input screen when calibrating. To do this,
SD54762 $SNS_MEA_FUNCTION_MASK_TOOL bit 4 must be set to 1.
In the following setting data, index [k] stands for the number of the current data field (probe
number -1) of the probe.
SD54633 $SNS_MEA_TP_TYPE[k]
= 0
= 101
= 201
= 301
The following setting data is used to define in which axes and directions it is possible to
calibrate a tool probe.
SD54632 $SNS_MEA_T_PROBE_ALLOW_AX_DIR[k]
= 133
Decimal place
ONES
542
Default value
Cube (default value)
Disk in XY, working plane G17
Disk in ZX, working plane G18
Disk in YZ, working plane G19
Default value
1. Axis
= 0 axis not possible
= 1 only minus direction
= 2 only plus direction
= 3 both directions
Calibrate measuring feedrate for
tool probe and tool measurement
with stationary spindle.
Probe type, cube/disk
Axes and directions for "calibration"
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
SINUMERIK Operate (IM9)