Siemens SINUMERIK 840D sl Commissioning Manual page 474

Configuring cycles
22.4 Milling
MD24810 $MC_TRACYL_ROT_SIGN_IS_PLUS_1
= 1
MD24820 $MC_TRACYL_BASE_TOOL_1[ ]
[0] = 0
[1] = 0
[2] = 0
Data set for the 2nd transformation in the channel
MD24200 $MC_TRAFO_TYPE_2
= 513
MD24210 $MC_TRAFO_AXES_IN_2
[0] = 3
[1] = 4
[2] = 1
[3] = 2
MD24220 $MC_TRAFO_GEOAX_ASSIGN_TAB_2
[0] = 1
[1] = 4
[2] = 3
MD24850 $MC_TRACYL_ROT_AX_OFFSET_2
= 0
MD24855 $MC_TRACYL_ROT_SIGN_IS_FRAME_2
= 1
MD24860 $MC_TRACYL_ROT_SIGN_IS_PLUS_2
= 1
468
Sign of the rotary axis for the 1st TRACYL transformation.
Vector of basis tool for the 1st TRACYL transformation in XYZ
Transformer type (513 = cylinder surface transformation with groove side offset)
Channel axis: Infeed axis perpendicular (radial) to rotary axis
Channel axis: Rotary axis
Channel axis: 1st axis of the machining plane parallel to the rotary axis
Channel axis: 2nd axis of the machining plane
Channel axis: 1st geometry axis
Channel axis: 2nd geometry axis
Channel axis: 3rd geometry axis
Offset of rotary axis for the 2nd TRACYL transformation
Offset of rotary axis for the 2nd TRACYL transformation
Sign of rotary axis for the 2nd TRACYL transformation
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
Z
A
X
Y
X
A
Z
SINUMERIK Operate (IM9)