Simulation and simultaneous recording
9.5 Clamping a blank
9.5
Clamping a blank
The blank clamping function allows you to select the clamping location for the blank
(unmachined part).
Preconditions
● The machine must provide several clamping options.
● In order that for simulation/simultaneous recording, the rotary axes are displayed at the
correct location, their positions in the machine coordinate system must be specified using
the following machine data:
MD53220 $MAS_AXIS_MCS_POSITION[n]
Function
Set the following channel-specific machine data:
MD52207 $MCS_USAGE_ATTRIB[n]
Bit 0
Bit 1
Bit 2
Bit 8
MD52214 $MCS_FUNCTION_MASK_MILL
Bit 1
116
Rotation around 1st geometry axis (for rotary axes)
Rotation around 2nd geometry axis (for rotary axes)
Rotation around 3rd geometry axis (for rotary axes)
List rotary axis for blank clamping (on milling machines)
List fixed table for blank clamping (on milling machines)
Position of the axis in the MCS
[n] 0 = X, 1 = Y, 2 = Z
Attribute of the axes in the channel
[n] channel axis number
Milling function screen
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
SINUMERIK Operate (IM9)