Siemens SINUMERIK 840D sl Commissioning Manual page 136

Tool management
12.1 Machine data for tool management
Enabling the multitool function
MD18080 $MN_MM_TOOL_MANAGEMENT_MASK
Bit
10 = 1
Enabling the graphic tool and magazine display function
MD52271 $MCS_TM_MAG_PLACE_DISTANCE
> 0
= 0
Supplementary conditions:
● MD52200 $MCS_TECHNOLOGY = 2 (milling) and
MD52201 $MCS_TECHNOLOGY_EXTENSION = 0
● Multitool function is not enabled.
Default settings for unloading/loading and relocating
MD52272 $MCS_TM_TOOL_LOAD_DEFAULT_MAG
MD52273 $MCS_TM_TOOL_MOVE_DEFAULT_MAG
MD52274 $MCS_TM_TOOL_LOAD_STATION
Input limits for wear input
MD51212 $MNS_TM_WRITE_WEAR_ABS_LIMIT
MD51213 $MNS_TM_WRITE_WEAR_DELTA_LIMIT
MD51214 $MNS_TM_WRITE_LIMIT_MASK
130
The multitool function is available.
The tools and magazine locations are displayed graphically.
The tools and magazine locations are not displayed graphically.
Distance between individual magazine
locations in the unit of measurement of
the basic NC system.
Default magazine for loading tools.
Default magazine for relocating tools.
Number of loading station.
Maximum value of the tool wear.
Maximum differential value of restricted tool
wear input.
Range of validity of the restricted tool wear
input.
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
SINUMERIK Operate (IM9)