Setting Up The Counterspindle Under Shopturn - Siemens SINUMERIK 840D sl Commissioning Manual

MD52230 $MCS_M_CODE_ALL_COOLANTS_OFF
= 9
MD52231 $MCS_M_CODE_COOLANT_1_ON
= 8
MD52232 $MCS_M_CODE_COOLANT_2_ON
= 7
MD52233 $MCS_M_CODE_COOLANT_1_AND_2_ON
= -1
SD55505 $SCS_TURN_ROUGH_O_RELEASE_DIST
= 1
= -1
SD55506 $SCS_TURN_ROUGH_'I_RELEASE_DIST
= 0.5
= -1
22.10.2

Setting up the counterspindle under ShopTurn

SINUMERIK Operate (IM9)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
This machine data is used to define the M function for switching off the coolant; which is
output when the tool is changed.
This machine data is used to define the M function for coolant 1, which is output when the
tool is changed.
This machine data is used to define the M function for coolant 2, which is output when the
tool is changed.
This machine data is used to define the M function for coolant 1 and 2, which is output
when the tool is changed.
Specifies the distance, by which the tool is retracted from the contour when removing
stock from an outer corner. This does not apply to stock removal at a contour (default
value).
The distance is internally defined.
Specifies the distance, by which the tool is retracted from the contour when removing
stock from an internal corner. This does not apply to stock removal at a contour (default
value).
The distance is internally defined.
Software option
You require the following software options in order to use the counterspindle on
your machine:
• "Travel to fixed stop with Force Control"
• "Synchronous spindle/multi-edge turning"
Configuring cycles
22.10 Turning with ShopTurn
M code for all coolants off
M code for coolant 1 on
M code for coolant 2 on
M code for both coolants on
Retraction distance for stock
removal during external machining
Retraction distance for stock
removal during internal machining
571