Siemens SINUMERIK 840D sl Commissioning Manual page 544

Configuring cycles
22.8 Measuring cycles and functions
MD52750 $MCS_J_MEA_FIXPOINT
MD52751 $MCS_J_MEA_MAGN_GLAS_POS
[0]
[1]
Checking and setting the general machine data
MD11450 $MN_SEARCH_RUN_MODE
Bit 1 = 1
MD11604 $MN_ASUP_START_PRIO_LEVEL
= 1 - 64
Setting channel-specific machine data
MD20050 $MC_AXCONF_GEOAX_ASIGN_TAB[ ]
[0]
[1]
[2]
MD20110 $MC_RESET_MODE_MASK
= 4045H
Bit 0 = 1
Bit 2 = 1
Bit 6 = 1
Bit 14 = 1
MD20112 $MC_START_MODE_MASK
= 400H
Bit 6 = 0
538
Position in the 1st axis
Position in the 2nd axis
Automatic ASUB start after output of the action blocks (see also
MD11620 $MN_PROG_EVENT_NAME). Alarm 10208 is not output until the ASUB is
completed.
Priorities for ASUP_START_MASK.
For measuring in JOG mode, all of the geometry axes must be available. Preferably
XYZ.
Minimum value
Basic control setting after power on and reset.
Minimum value
Definition of the basic control setting after NC start.
Z value for measurement with respect to
a fixed point
Zoom-in position for tool measurement
Programming search.
Priorities from which ASUP_START_MASK is
effective.
Assignment, geometry axis to channel axis.
Defines the basic control settings after reset /
TP end,
Definition of the basic control setting after part
program start.
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
SINUMERIK Operate (IM9)