Siemens SINUMERIK 840D sl Commissioning Manual page 775

Dialog selection
9.1 Dialog selection using PLC softkeys
Configuration
Description of the procedure:
● The systemconfiguration.ini contains a section [keyconfiguration]. The entry specifies an
● A number is given as an action. A "Run MyScreens" call is involved if the number is
● A section for defining the action to be performed must be created in the easyscreen.ini
● The action numbers (which were given in the systemconfiguration.ini → see Action:=...)
Selecting softkey menus via PLC softkeys
"Run MyScreens" makes it possible to select "Run MyScreens" softkey menus and
"Run MyScreens" dialogs via PLC softkeys. This can only be done if the "action" attribute to
be specified when configuring the relevant PLC softkeys has a value greater than or equal to
100.
PLC softkeys are configured in the file
[keyconfiguration]:
[keyconfiguration]
KEY75.1 = Area:=area, Dialog:=dialog, Screen:=screen, Action:= 100,
The LM and LS commands to be executed upon activation of the relevant PLC softkeys are
configured in the easyscreen.ini file. The names of the sections that are used for the purpose
of configuration are structured as follows:
SINUMERIK Integrate Run MyScreens (BE2)
Programming Manual, 03/2013, 6FC5397-1DP40-3BA1
action for a special PLC softkey.
greater than or equal to 100.
file. The name of the section is based on the name of the operating area and the dialog
name (see entry under [keyconfiguration] → Area:=..., Dialog:=...) → [<Area>_<Dialog>]
→ e.g. [AreaParameter_SlPaDialog].
are defined in this section. There are two commands involved:
1. LS("Softkey menu1","param.com") ... Loading a softkey menu
2. LM("Screen form1","param.com") ... Loading a screen form
systemconfiguration.ini
9
in the section
157