Siemens SINUMERIK 840D sl Commissioning Manual page 549

Decimal place
TENS
HUNDREDS
Example
If the general setting data SD54632 $SNS_MEA_T_PROBE_ALLOW_AX_DIR[k] has the
value 123, the tool probe is calibrated as follows in the G17 plane:
● X in both directions
● Y only in plus direction
● Z only in minus direction
SD54631 $MNS_MEA_T_PROBE_DIAM_LENGTH[k]
= 0
General cycle machine/setting data for tool probe
MD51780 $MNS_J_MEA_T_PROBE_DIAM_RAD[k]
= 0
SD54634 $SNS_MEA_TP_CAL_MEASURE_DEPTH[n]
= 2
MD51752 $MNS_J_MEA_M_DIST_TOOL_LENGTH
= 2
SINUMERIK Operate (IM9)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
2. Axis
= 0 axis not possible
= 1 only minus direction
= 2 only plus direction
= 3 both directions
3. Axis
= 0 axis not possible
= 1 only minus direction
= 2 only plus direction
= 3 both directions
Default value
Default value
Default value
Default value
Configuring cycles
22.8 Measuring cycles and functions
Effective diameter of the tool probe
for length measurement.
Effective diameter of the tool probe
for radius measurement.
Distance between the tool probe
upper edge and the milling tool
lower edge.
Measuring path to measure the tool
length.
543