Workpiece Measurement, General - Siemens SINUMERIK 840D sl Commissioning Manual

Configuring cycles
22.8 Measuring cycles and functions
22.8.4.1

Workpiece measurement, general

Using the following general and channel-specific cycle setting data, you can appropriately
adapt workpiece measurement to the specific requirements in the "Program" operating area.
Precondition
You have already made the settings from the following section:
See also: Measuring cycles and measurement functions, general (Page 531)
Settings
General cycle setting data
SD54760 $SNS_MEA_FUNCTION_MASK_PIECE
Bit 1
Bit 3
Bit 4
Bit 6
Bit 7
Bit 8
Bit 9
Bit 10
Bit 11
Bit 12
Bit 13
Bit 14
Bit 15
Bit 16
Bit 17
Bit 18
Bit 19
Bit 20
Bit 21
Bit 22
Bit 24
Bit 25
552
Display select softkey 3D measurement
Enable probe calibration field to be selected
Select calibration input measuring feed
Enable WO to be selected in the basis reference (SETFRAME)
Enable WO to be selected in the channel-specific basis frame
Enable WO to be selected in the basis frame
Enable WO to be selected in the adjustable frame
Enable WO, coarse and fine, to be selected
Select tool offset, geometry and wear
Select tool offset, not inverted and inverted
Select tool offset L1, R or L1, L2, L3 R
Select tool offset, zero offset (_TZL)
Select tool offset, dimensional difference monitoring (_TDIF)
Select workpiece measurement with spindle reversal
Select align workpiece probe in the switching direction
Select number of measurements (_NMSP)
Select offset with mean value generation (_TMV)
Select experience values (_EVNUM)
Select total setting-up offset
Select calibration to unknown or to known center point
Select calibration with/without position deviation
Select zero offset when measuring the angulation of the spindle
Settings for the input screen, measuring
cycles in AUTOMATIC, workpiece
measurement.
1)
1)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
SINUMERIK Operate (IM9)