Fetch Temperatures - Siemens SINUMERIK 840D sl Commissioning Manual

Data overview
The "S1 Spindle Diagnostics" window shows the following information:
Parameter
Operating hours
•
•
Number of clamping cycles (tool change)
Motor temperature
Clamping system (sensor 1)
Piston free (sensor 4)
Shaft in the change position (sensor 5)
Load classification
Nominal residual use
Maximum speed
*)
18.16.2

Fetch temperatures

To ensure a full temperature protection, a diagnosis of the temperatures can also be
performed at low speeds or standstill. Which temperatures are displayed depends on the
number and the mounting location (e.g. S6) of the used sensors, for example:
● Motor temperature (KTY84)
● Winding, full motor protection (PTC)
● S6, e.g. bearing temperature (KTY)
Procedure
SINUMERIK Operate (IM9)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
Spindle under control
Spindle under speed
*)
*)
If at least one collision was detected, "Load classification" and "Nominal residual use" will be
grayed-out because they no longer display any reliable values.
1. The "S1 Spindle Diagnostics" window is open.
2. Press the "Temperatures" softkey.
The "S1 Temperatures" window opens and displays the acquired data.
3. Press the "Histogram" softkey to track the temperature change of a
sensor over a certain period.
- OR -
Press the "Back" softkey to return to the data overview.
Service and diagnostics
18.16 Spindle diagnostics
Value
h
°C
V
%
h
rpm
407