Siemens SINUMERIK 840D sl Commissioning Manual page 309

Column
Start
/Priority
Display area
Channel
Editing the list of VNC connections
See also
Displaying the available operator panels (Page 301)
SINUMERIK Operate (IM9)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
Description
Specifies whether the TCU is to be started active, i.e. as operator panel.
Start-up priority: Specifies the priority of the TCU connection to be used.
Any value greater than 0 is permitted. The larger the value, the lower the connection
priority.
Specifies which HMI screen is displayed when activating the TCU.
Specifies which channel is displayed when activating the TCU.
1. The "Available Operator Panels ..." window is open.
2. Press the "Change" softkey.
The information on the VNC connections can be edited.
- OR -
3. Press the "Add" softkey to establish a new VNC connection.
- OR -
4. Press the "Remove" softkey to remove a selected VNC connection from
the list.
- OR -
5. Press the "Move up" or "Move down" softkey to move a VNC
connection within the list.
6. Make the required change and press the "OK" softkey.
- OR -
Press the "Cancel" softkey to cancel the changes.
Configuring operator panels
17.2 Configuring VNC connections
303