Siemens SINUMERIK 840D sl Commissioning Manual page 552

Configuring cycles
22.8 Measuring cycles and functions
SD54693 $SNS_MEA_T_MAX_STEPS
= 10
*)
r
b
n
①
Figure 22-10 Single cutting edge measurement
General cycle setting data for correction using the correction tables when forming measurements with
rotating spindle.
SD54691 $SNS_MEA_T_PROBE_OFFSET
= 0
= 1
= 2
SD54689 $SNS_MEA_T_PROBE_MANUFACTURER
= 0
= 1
= 2
546
Default value
*)
If the value = 0, then the "highest point on the longest cutting edge" is not sought, but the
measured value of the contact with the rotating spindle taken.
Effective radius of the tool
Arc distance = SD54692
Maximum number of probe contacts = SD54693
1. Measuring point
No data, default value
Correction in the cycle. This is only effective if
SD54689 $SNS_MEA_T_PROBE_MANUFACTURER>0.
Correction using user-defined correction table
No data, default value
TT130 (Heidenhain)
TS27R (Renishaw)
Maximum number of probe contacts
for single cutting edge measurement
of the radius.
Activate the measuring result
compensation
Activates pre-configured
compensation tables for several tool
probe models (customer-specific)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
SINUMERIK Operate (IM9)