Configuring new list parameters based on an existing list parameter.
Assign a new parameter name and enter only the changed data:
Entries
Base
1. Example
<PARAMETERCONFIGURATION>
</PARAMETERCONFIGURATION>
2. Example
Entries
Base
SINUMERIK Operate (IM9)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
Meaning
Assign new parameter name
See 1st example: Text
Name of the parameter on which the new parameter is based.
See 1st example:
Also enter only the changed data here. All other data is taken from the existing
parameter.
See 1st example: Column width changed to 46 pixels. Number of decimal places
changed to 1.
<NewGeoRadius>
<Base value="GeoRadius" type="QString" />
<Width value="46" type="int" />
<DisplayMode value="DoubleMode" type="QString" />
<DecimalPlaces value="1" type="int" />
</NewGeoRadius>
Meaning
Assign new cutting edge parameter name
The name is
Name of the parameter on which the new parameter is based.
In the following example, the
Also enter only the changed data here. All other data is taken from the existing
cutting edge parameter.
The following entries are changed:
Field type: Input/output field for states
Value output: All characters
Bit mask: Bit 0
Column width changed to 17 pixels.
Header changed to
Text in the tooltip changed to
"NewGeoRadius"
parameter is used as a template.
"GeoRadius"
in the following example.
"EdgeUser_1_Bit0"
"EdgeUser_1"
"TM_HL_EDGE_USER_1_Bit0"
"TM_TT_EDGE_USER_1_Bit0"
Tool management
12.2 Configuring the user interface
parameter is used as template.
155