Siemens SINUMERIK 840D sl Commissioning Manual page 468

Configuring cycles
22.3 Manufacturer cycles
Marker
_M100
_M101
_M102
_M103
_M110
_M111
_M112
_M113
_M114
_M120
_M121
_M122
_M123
_M125
_M126
_M131
_M132
_M135
_M136
_M140
_M141
_M142
_M150
_M151
_M152
_M153
_M154
_M155
_M156
_M157
462
Action
Drawer:
Cut-off completed
Tool change
After end of tool change cycle (with tool change)
Before tool change on retraction plane
Before cutting edge reselection
After end of tool change cycle (without tool change)
Definition: Coupling of counterspindle / main spindle
After COUPOF switch off position control
Definition: Coupling, main/counterspindle
After COUPOF switch off position control
Changeover to main spindle
Changeover to counterspindle
Start of program (ShopTurn program)
End of program header (ShopTurn program)
End of program loop (ShopTurn program)
End of program (ShopTurn program)
Block search
2-channel stock
removal:
Position before cut-off
Open during cut-off
Close after cut-off
Before tool change
After tool change
After tool change (new tool from ShopTurn)
Leading channel before Balance Cutting
Leading channel after Balance Cutting
Following channel before Balance Cutting
Following channel after Balance Cutting
Start machining in the leading channel
End machining in the leading channel
Start machining in the following channel
Start machining in the following channel
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
SINUMERIK Operate (IM9)