Siemens SINUMERIK 840D sl Commissioning Manual page 853

start snc
Syntax:
Alternative names:
Privilege level:
This command starts the "System Network Center". To operate it, you will need a mouse.
The "System Network Center" you can end with "Exit". If you do not wish to end the "System
Network Center", then switch to the HMI with the following key combination:
<Recall> + <MENU SELECT> (Area switchover key) or
<F9> + <F10> on an external keyboard
Reference
A description of the settings in the "System Network Center" is provided in the Operating
Components and Networking Manual.
NCU operating system (IM7)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
sc start snc
---
service
Configuring the system
2.5 Description of the actions
57