Siemens SINUMERIK 840D sl Commissioning Manual page 565

Decimal place
ONES
TENS
HUNDREDS
Example
If the general cycle machine data SD54647 $SNS_MEA_TPW_AX_DIR_AUTO_CAL has the
value 123, the tool probe is calibrated as follows in the G17 plane:
● X in both directions
● Y only in plus direction
● Z only in minus direction
Monitoring when measuring with a rotating spindle
SD54670 $SNS_MEA_CM_MAX_PERI_SPEED[0]
= 100
SD54671 $SNS_MEA_CM_MAX_REVOLUTIONS[0]
= 1000
SINUMERIK Operate (IM9)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
1. Axis
= 0
= 1
= 2
= 3
2. Axis
= 0
= 1
= 2
= 3
3. Axis
= 0
= 1
= 2
= 3
Default value
Default value
axis not possible
only minus direction
only plus direction
both directions
axis not possible
only minus direction
only plus direction
both directions
axis not possible
only minus direction
only plus direction
both directions
Configuring cycles
22.8 Measuring cycles and functions
Maximum permissible peripheral
speed of the tool to be measured.
Maximum permissible tool speed of
the tool to be measured. The speed is
automatically reduced when
exceeded.
559