Siemens SINUMERIK 840D sl Commissioning Manual page 1034

Configuration of the system
3.9 Configuring the SITOP UPS module for use with the PCU Base Software
Procedure
Proceed as follows to configure the SITOP software for use with the PCU Base Software:
1. Switch to the SITOP monitor.
2. Make the following settings on the "Generally" tab in the "SITOP-DC-UPS Configuration"
dialog box.
Note
Deactivating the monitoring window
Display of the monitoring window can cause malfunctioning of the HMI software.
Figure 3-1
3. Confirm the settings with "Save."
32
Settings
Serial interface
Action on status change > Monitoring window
SITOP-DC-USV Configuration - Tab "Generally"
Selection
In the "serial interface" drop down list box,
select "UPS."
Clear the check box "Display monitoring
window after"
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
PCU Base Software (IM10)