Siemens SINUMERIK 840D sl Commissioning Manual page 109

Additional parameter assignments
We recommend the following additional parameter assignments:
Handwheel
MD11346 $MN_HANDWH_TRUE_DISTANCE = 3
MD11602 $MN_ASUP_START_MASK bit 0, 3 =1
MD20150 $MC_G_CODE_RESET_VALUE [7] = 2
MD20624 $MC_HANDWH_CHAN_STOP_COND = 0xFFFF
MD32084 HANDWH_STOP_COND = 0x7FF
MD52212 FUNCTION_MASK_TECH Bit 9 = 1
Working area limits
MD28600 $MC_MM_NUM_WORKAREA_CS_GROUPS > 0
MD20150 $MC_GCODE_RESET_VALUES[59] = 2
Feedrate
SD42600 $SC_JOG_FEED_PER_REV_SOURCE = -3
SD43300 $SA_ASSIGN_FEED_PER_REV_SOURCE [X
axis] = -3
SD43300 $SA_ASSIGN_FEED_PER_REV_SOURCE [Z
axis] = -3
Note
Ensure that the axis-specific setting data SD43300
SA_ASSIGN_FEED_PER_REV_SOURCE are set the same.
References
● Operating:
● Programming:
SINUMERIK Operate (IM9)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
Operating Manual, Turning/Milling, Chapter "Working with a manual machine"
Programming Manual, Fundamentals; Chapter "Working area limit"
Customizing the "Machine" operating area
8.9 Manual machine
Handwheel path or velocity
specification
Ignore stop conditions for ASUB
Delete position of the G groups; run-
up G54 active
Definition of the behavior of traveling
with handwheel, channel-specific
Behavior, handwheel travel
Function screen form across
technologies; work offset via softkey
Number of coordinate system-specific
working area limits
Delete position of the G groups;
activate working area limits of the
group
Revolutional feedrate control in JOG
mode
Revolutional feedrate for positioning
axis X
Revolutional feedrate for positioning
axis Z
103