Siemens SINUMERIK 840D sl Commissioning Manual page 1028

Configuration of the system
3.7 Setting the screen resolution
3.7 Setting the screen resolution
You can set the screen resolution directly in Windows 7 or use the PCU Base Software
specific filetcu.ini.
The settings in tcu.ini overwrite the Windows system settings. Compared with Windows, they
offer additional functions for switching over the resolution of the PCU 50.5 depending on, for
example, the screen connected during booting.
● Information about the configuration file tcu.ini is provided in the next chapter (Page 26).
● Information for setting the screen resolution under Windows 7 is provided on the
Microsoft website: Changing the screen resolution
us/windows7/change-your-screen-resolution)
3.8 Set the resolution in the tcu.ini
Overview
The system behavior during booting for the screen resolution is set in file
You will find a template of the
Control\SIEMENS\System\etc\
Do not overwrite this template, but create your own
(see ChapterDirectory structure and file conventions (Page 11)).
Further information
● Chapter Directory structure and file conventions (Page 11).
● Operator Components Manual, Chapter "Networking"
Set the resolution when booting up the PCU
The following options are available for selection in section
0 = SYSTEM
1 = AUTO_OP_1 (Voreinstellung)
2 = AUTO_OP_2
3 = AUTO_MON_1
4 = AUTO_MON_2
5 = 640X480
6 = 800X600
7 = 1024X768
8 = 1280X1024
The meanings of the settings are as follows:
26
under
tcu.ini C:\ProgramData\Siemens\Motion
tcu.ini
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
(http://windows.microsoft.com/en-
tcu.ini
inside one of the user directories
in the
# RESOLUTION
PCU Base Software (IM10)
.
:
tcu.ini