Siemens SINUMERIK 840D sl Commissioning Manual page 160

Tool management
12.2 Configuring the user interface
Entries
DecimalPlaces
ItemType
BitMask
AccessLevel
UpperLimit
LowerLimit
Example
In the following example, the
Only enter the modified data.
<PARAMETERCONFIGURATION>
</PARAMETERCONFIGURATION>
154
Meaning
UnsignedDoubleMode
Length
Angle
LinearFeedPerTime
LinearFeedPerRevolution
LinearFeedPerTooth
RevolutionSpeed
ConstantCuttingSpeed
Number of decimal places if "DoubleMode" or "UnsignedDoubleMode" is
selected in the DisplayMode.
See example: Two decimal places are entered.
Field types in which a value is displayed.
TextField
TextFieldReadOnly
CheckBox
CheckBoxReadOnly
Bit mask for the display of a bit from a value. The bit mask is entered as integer
value. Bit 0 → 1, Bit 1 → 2, Bit 2 → 4
Value for the access level that is used for these parameters in the user interface.
Value range 1 to 7
Upper input limit for these parameters in the user interface.
Only applies for numerically entered parameters.
Lower input limit for these parameters in the user interface.
Only applies for numerically entered parameters.
<GeoRadius>
<Width value="53" type="int" />
<DisplayMode value="DoubleMode" type="QString" />
<DecimalPlaces value="2" type="int" />
</GeoRadius>
Unsigned values with decimal places
The number of decimal places is specified in
"DecimalPlaces"
Specified length
Specified angle
Linear feed in mm/minute
Linear feed in mm/revolution
Linear feed in mm/tooth
Speed
Constant cutting rate
Input/output field for values and texts
Output field for values and texts
Input/output field for states
Output field for states
parameter is used.
<GeoRadius>
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
SINUMERIK Operate (IM9)