Siemens SINUMERIK 840D sl Commissioning Manual page 415

The sensors in the motor provide information about the clamping device and the orientation
of the tool in the spindle:
Sensor
S1
S4
S5
Procedure
Speed limitation
SINUMERIK Operate (IM9)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
Meaning
Clamped state
Piston free
Shaft in the change position
1. The "S1 Spindle Diagnostics" window is open.
2. Press the "Clamping system" softkey.
The "S1 Clamping System" window opens and displays the acquired
data. The clamping state is displayed as a histogram.
3. Press the "Speed limitation" softkey to change the limit values for the
speeds of the clamped states.
The "S1 Speed Limitations" window opens.
4. Press the "Change" softkey to enter the the desired speed limitations
depending on the clamped state and confirm with "OK".
- OR -
3. Press the "Cycle counter diagnostics" softkey to fetch the clamping
times and perform a diagnosis of the clamping system.
The "S1 Cycle Counter and Diagnostics" window opens and displays
the acquired data.
- OR -
3. Press the "Back" softkey to return to the data overview.
Service and diagnostics
18.16 Spindle diagnostics
Released
Clamped with tool
Clamped without tool
409