Tool Measurement In Milling - Siemens SINUMERIK 840D sl Commissioning Manual

SD54604 $SNS_MEA_WP_TRIG_PLUS_DIR_AX2[n]
SD54605 $SNS_MEA_WP_TRIG_MINUS_DIR_AX3[n]
SD54606 $SNS_MEA_WP_TRIG_PLUS_DIR_AX3[n]
SD54607 $SNS_MEA_WP_POS_DEV_AX1[n]
SD54608 $SNS_MEA_WP_POS_DEV_AX2[n]
SD54609 $SNS_MEA_WP_STATUS_RT
SD54610 $SNS_MEA_WP_STATUS_GEN[n]
SD54611 $SNS_MEA_WP_FEED[n]
22.8.4.3

Tool measurement in milling

Settings
SD54633 $SNS_MEA_FUNCTION_MASK_TOOL
Bit 3
Bit 4
Bit 5
Bit 7
Bit 8
Bit 9
Bit 10
Bit 11
Bit 12
Bit 13
1)
SINUMERIK Operate (IM9)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
Setting for the input screen, measuring cycles in the automatic mode, tool measurement,
enable tool probe calibration data field to be selected
Select calibration input measuring feed (VMS)
Select input feedrate and spindle speeds when probing
Select measurement in MCS and WCS
Select measurement, absolute and incremental
Select tool offset, geometry and wear
Select individual cutting edge measurement
Selects spindle reversal when calibrating in the plane
Select number of measurements (_NMSP)
Select experience values (_EVNUM)
Input, measurement feedrate is valid for AUTOMATIC and JOG
22.8 Measuring cycles and functions
Trigger point, plus direction,
2nd measuring axis in the plane.
Trigger point, minus direction,
3rd measuring axis in the tool direction.
Trigger point, plus direction,
3rd measuring axis opposite to the tool
direction. In the default case = 0.
Position deviation,
1st measuring axis in the plane.
Position deviation,
2nd measuring axis in the plane.
Calibration status of the axis positions
Calibration status
Measuring feedrate when calibrating
Setting for the input screen, measuring
cycles in the automatic mode, tool
measurement
1)
Configuring cycles
555