Siemens SINUMERIK 840D sl Commissioning Manual page 393

Attributes
SINUMERIK Operate (IM9)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
Meaning
Interpolation clock cycle (IPO clock cycle)
•
Interpolation cycle (IPO2)
•
Position control clock cycle (servo clock cycle)
•
PLC cycle OB1
•
Drive trace rate
•
Start geometry axis/direction change
•
Stop geometry axis
•
Machine axis start / direction change
•
Machine axis stop
•
NC start (program runs)
•
NC start (program ran)
•
Start of the data recording
•
Block start, type 1 or block end (all program levels, without intermediate
•
blocks)
Block start, type 2 or block end (all program levels, with intermediate
•
blocks)
Block start, type 3 or block end (all main programs, without intermediate
•
blocks)
Block start or block end, block search (all program levels, without
•
intermediate blocks)
Geo axis start / direction change (2nd event)
•
Geo axis stop (2nd event)
•
Block start, type 2 (2nd event: all program levels, without intermediate
•
blocks)
Block end, type 2 (2nd event: all program levels, with intermediate blocks)
•
Block start, block advance, type 1 (2nd event)
•
OEM test event 1 (non-cyclic, block advance)
•
OEM test event 2 (non-cyclic, main run)
•
Activate/deactivate synchronized action
•
Synchronized action initiated (condition fulfilled)
•
Signaled alarm
•
Cancel softkey pressed
•
Program level change
•
Block end (Interpreter)
•
Trace end (last event!)
•
Start trace
•
Service and diagnostics
18.14 Trace
387