With the following setting data, additional G functions can be programmed in
CUST_832.SPF for using multi-axis programming:
SD55220 $SCS_FUNCTION_MASK_MILL_TOL_SET Function screen form, high speed settings
Bit 1
Example
Using _MOTOL in CUST_832.SPF for the marker for finishing:
_M_FINISH:
IF _MOTOL==1
ELSE
ENDIF
...
22.8
Measuring cycles and functions
22.8.1
Measuring cycles and measurement functions, general
Precondition
Two types of electronic probes are used for measuring:
● Probe to measure the workpiece
● Probe to measure the tool
The electronic probe must be connected to the NCU 7x0.
The electronic probe is only called probe in the following document
References
NCU, Digital Inputs/Outputs Device Manual
SINUMERIK Operate (IM9)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
Orientation tolerance (OTOL) as a factor of the tolerance (CTOL) or directly entered
ORISON
ORISOF
CYCLE832
; if multi-axis programming
; no multi-axis programming
Configuring cycles
22.8 Measuring cycles and functions
531