Machine Identity - Siemens SINUMERIK 840D sl Commissioning Manual

18.6

Machine identity

You can store important information about the machine electronically that until now has only
been available on paper for the end user notification administration (EUNA). If service is
required, these entries can be viewed using remote diagnostics, or can be directly
transferred to EUNA via the drives that have been set up.
You can store the following data for each machine:
● Machine type
● Machine number
● Manufacturer information
● Dealer information
● End user information
● Component list of the control technology that has been installed
● Logbook entries for changes to the machine
You enter the machine information and address information in the "identSNAPSHOT"
window. The information can be either manually entered or using selection files.
Machine information
Entries
Machine No.
Machine name
Machine type
Address information
Under Addresses you can enter the following data for the manufacturer/manufacturer's
regional office, dealer and end customer:
● Customer number
● Manufacturer name and, if required, Branch name / Dealer name / End user name
● Street, Postal code/ZIP code, Location, Country (can be selected from a selection list),
● Address of contact: Name, Phone, Fax, E-mail, URL
SINUMERIK Operate (IM9)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
Meaning
The unique machine number (serial number of the CompactFlash card) is
displayed in the header. This number serves as information only and cannot
be changed.
The manufacturer assigns a unique machine number in this field which is
stored in machine data MD17400 $MN_OEM_GLOBAL_INFO.
Note: The machine name is a mandatory field. No data can be stored until this
field is completed.
Machine type.
Region/State
Service and diagnostics
18.6 Machine identity
327