Siemens SINUMERIK 840D sl Commissioning Manual page 478

Configuring cycles
22.5 Turning
Note
MD52207[n] bit 4 = *)
Bit 4 can be set from the operator's view (values as specified) or according to DIN ("0" and
"1" are then interchanged).
Dimensions
To define the reference point for moving the counterspindle, you must first communicate the
dimensions of the counterspindle. You can either enter the dimensions in the following axis-
specific cycle machine data or in the menu "Parameter" -> Setting data -> Spindle chuck
data" Changes to the machine data are automatically accepted in the menu and vice versa.
MD53240 $MAS_SPINDLE_PARAMETER[ ]
[0]
[1]
[2]
MD53241 $MAS_SPINDLE_CHUCK_TYPE[ ]
= 0
= 1
Additional settings
The M code, e.g. M34 or M1 = 34 for the spindle chuck is defined in the following machine
data. The manufacturer cycle CUST_TECHCYC.SPF also takes the M functions from the
following machine data:
MD52250 $MCS_M_CODE_CHUCK_OPEN[ ]
[0]
[1]
MD52251 $MCS_M_CODE_CHUCK_CLOSE_OPEN_ROT[ ]
[0]
[1]
472
Chuck dimensions
Stop dimensions
Jaw dimensions
Clamping, outer
Clamping, inner
Main spindle
Counterspindle
Main spindle
Counterspindle
Spindle chuck data
Spindle jaw type
M code for open chuck with
stationary spindle
M code for open chuck with spindle
rotating
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
SINUMERIK Operate (IM9)