Siemens SINUMERIK 840D sl Commissioning Manual page 540

Configuring cycles
22.8 Measuring cycles and functions
MD52740 $MCS_MEA_FUNCTION_MASK
Bit 0
Bit 1
Bit 16
MD54740 $SNS_MEA_FUNCTION_MASK
Bit 0
Bit 1
Bit 2
Bit 3
Bit 4
Bit 16
Bit 17
Bit 18
Bit 19
MD55740 $SCS_MEA_FUNCTION_MASK
Bit 0
Bit 1
Bit 2
Bit 3
Bit 4
Bit 5
Bit 6
Bit 7
Bit 8
534
Measuring input, workpiece probe
= 0 Workpiece probe at the CNC measuring input 1, active - default
= 1 Workpiece probe at the CNC measuring input 2, active
Workpiece measurement, functional behavior of a third geometry axis (Y axis) when
turning, based on the machining plane G18!
Measuring input, tool probe
= 0 Tool probe at the CNC measuring input 1, active
= 1 Workpiece probe at the CNC measuring input 2, active - default
Repeat measurement, workpiece measurement after exceeding a dimensional difference
(parameter _TDIF) and or confidence range (parameter _TSA)
Repeat measurement workpiece measurement with alarm and cycle stop at M0
Workpiece measurement: M0 for tolerance alarms 62304 oversize, 62305 undersize,
62306 permissible dimensional difference exceeded
Accept calibrated workpiece probe radius in the tool data.
For turning-milling technology, the calibration/measuring plane is different.
Repeat measurement, tool measurement after a dimensional difference has been fallen
below (parameter _TDIF) and or confidence range (parameter _TSA)
Repeat measurement tool measurement with alarm and cycle stop at M0
Workpiece measurement: M0, after the permissible dimensional difference has been
exceeded
Tool measurement, milling tool: Spindle speed reduction at the last probing
Collision monitoring using workpiece probe for intermediate positioning
Coupling the spindle alignment with coordinate rotation in the active plane, for workpiece
measurement with multiprobe in the automatic mode
Direction of rotation of the spindle positioning for workpiece measurement regarding active
coupling of the spindle alignment with coordinate rotation in the active plane
For workpiece measurement, number of repeat measurements if the probe does not
switch
Measuring feed rate for workpiece measurement
Retraction velocity from the measuring point for workpiece measurement
Workpiece measurement, probe activation/deactivation when positioning the spindle
Measure kinematics, scaling basis for the orientation vectors
Measure kinematics, measurement with active TRAORI or TCARR (CYCLE 800)
Measuring cycles function mask
Measuring cycles function mask
Measuring cycles function mask
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
SINUMERIK Operate (IM9)