Siemens SINUMERIK 840D sl Commissioning Manual page 1041

Installing and configuring updates and automation
software
4.1 Overview
Once you have completed installation of the PCU Base Software Windows 7 and possibly
configured the network settings, you can set up handling of the security updates, patches,
and software installations or install them directly.
● You will find information about Windows updates and the network security of an
● The PCU Installer (Page 50) will assist you with automatic installation of setup packages.
● You can install SINUMERIK Operate (Page 41) or other HMI software and at the same
● To prevent operation of the HMI software from being interrupted by key combinations
● You can install STEP 7 and the SINUMERIK add-on (Page 47) and add a softkey to the
● If you want to transfer existing data to the newly installed automation software, read
PCU Base Software (IM10)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
automation system in Chapter Patch management and security updates (Page 40).
time (Page 41) orsubsequently (Page 43) set it up for autologon mode.
such as CTRL+ALT+DEL, you can activate and configure the key filter (Page 45).
HMI software to start STEP 7 (Page 49).
ChapterMigration (Page 56).
4
39