Inclined Y Axis (Traang) Under Shopturn - Siemens SINUMERIK 840D sl Commissioning Manual

Configuring cycles
22.10 Turning with ShopTurn
Setting up
In addition, set the following channel-specific configuration machine data:
MD52214 $MCS_FUNCTION_MASK_MILL
Bit 3
Bit 4
Note
The face end machining is automatically integrated in the cycles, with the exception of the
straight line and circle.
You can select the functions for these two cycles in the "Program" operating area at "Straight
line" and "Circle".
References
Additional information on face end machining is provided in:
Function Manual, Extended Functions; Kinematic Transformation (M1): TRANSMIT
22.10.6

Inclined Y axis (TRAANG) under ShopTurn

576
Enable "internal / rear" machining in ShopTurn masks (screens) that define the machining
plane themselves.
If you have implemented the "Clamp/release spindle" function using the machine
manufacturer cycle CUST_TECHCYC.SPF, then using this machine data, you can
activate the "Clamp/release spindle" parameter in the drilling and milling screens.
= 0 The "Clamp/release spindle" parameter is not displayed in the drilling and milling screens.
ShopTurn automatically clamps the spindle if it makes sense for the particular machining
operation.
= 1 The "Clamp/release spindle" parameter is displayed in the drilling and milling screens. The
operator decides for which machining operation the spindle should be clamped.
Software option
You require the following software option in order to use the inclined Y axis
function on your machine:
"Inclined axis"
Function screens, ShopTurn.
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
SINUMERIK Operate (IM9)