Siemens SINUMERIK 840D sl Commissioning Manual page 473

MD28082 $MC_MM_SYSTEMFRAME_MASK
= 21H
Bit 0 = 1
Bit 5 = 1
Bit 6 = 1
General settings for the transformation
MD10602 $MN_FRAME_GEOAX_CHANGE_MODE
= 1
Data set for the 1st transformation in the channel
MD24100 $MC_TRAFO_TYPE_1
= 512
MD24110 $MC_TRAFO_AXES_IN_1
[0] = 3
[1] = 4
[2] = 1
[3] = 2
MD24120 $MC_TRAFO_GEOAX_ASSIGN_TAB_1
[0] = 1
[1] = 4
[2] = 3
MD24800 $MC_TRACYL_ROT_AX_OFFSET_1
= 0
MD24805 $MC_TRACYL_ROT_AX_FRAME_1
= 1
SINUMERIK Operate (IM9)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
Default setting
System frame for actual value setting and scratching
System frame for cycles
System frame for transformations
The actual total frame (zero offsets) is recalculated when switching over geometry axes
(selecting - deselecting TRACYL).
Transformer type (512 = cylinder surface transformation without groove side offset)
Channel axis: Infeed axis (tool axis) perpendicular (radial) to the rotary axis
Channel axis: Rotary axis
Channel axis: 1st axis of the machining plane parallel to the rotary axis
Channel axis: 2nd axis of the machining plane
Channel axis: 1st geometry axis
Channel axis: 2nd geometry axis
Channel axis: 3rd geometry axis
Offset of rotary axis for the 1st TRACYL transformation.
Axial offset of rotary axis for the 1st TRACYL transformation.
Configuring cycles
System frames (SRAM)
Frames when switching over geometry
screens
Definition of transformation 1 in the
channel.
Axis assignment for the 1st
transformation in the channel
Assignment of the geometry axes to
channel axes for transformation 1.
22.4 Milling
Z
A
X
Y
X
A
Z
467