Siemens SINUMERIK 840D sl Commissioning Manual page 102

Customizing the "Machine" operating area
8.4 Configuring the channel operational message
58 =
60 =
61 =
62 =
63 =
64 =
65 =
66 =
67 =
68 =
69 =
70 =
71 =
72 =
73 =
74 =
75 =
76 =
77 =
78 =
79 =
80 =
81 =
82 =
83 =
84 =
85 =
[CondDelayTime]
Default delay time = 1000
1 = 0
2 = 0
3 = 0
4 = 0
5 = 0
6 = 0
7 = 0
8 = 0
9 = 0
10 = 0
12 = 0
16 = 0
17 = 0
18 = 0
19 = 0
22 = 0
23 = 0
32 = 0
45 = 0
76 = 0
96
condwait.png ; Axis replacement: Axis is OEM axis
condwait.png ; Coupled following axis
condwait.png ; Coupled-motion following axis
condwait.png ; Coupled slave axis
condstop.png ; Stop at cycle end M0
condstop.png ; Stop at cycle end M1
condwait.png ; Wait: Axis is at fixed stop
condwait.png ; Master-slave switchover active
condwait.png ; Axis replacement: Axis is single axis
condstop.png ; Stop: Target reached after block search
condwait.png ; Synchronism: Synchronous spindle
condwait.png ; Deactivation position synch. spindle
condwait.png ; Waiting for transformer axis enable
condstop.png ; Waiting because of possible collision
condstop.png ; Jog: Position reached
condstop.png ; Jog: Direction blocked
condwait.png ; Brake request
condwait.png ; Wait: G4 still: U
condstop.png ; Axial feed disable from PLC
condstop.png ; Waiting for axial feed enable
condwait.png ; Axial feed disable from SYNACT
condwait.png ; Waiting for master spindle speed
condwait.png ; Waiting for parameter set change
condwait.png ; Waiting for end of motion before transformation change
condwait.png
condwait.png
condwait.png
; No NC ready
; No mode group ready
; EMERGENCY STOP active
; Alarm with stop active
; M0/M1 active
; Block in SBL mode terminated
; NC stop active
; Read-in enable missing
; Feed enable missing
; Dwell time active
; Axis enable missing
; Waiting for other channel
; Waiting for feedrate override
; Error in NC block
; Waiting for external NC blocks
; Spindle enable missing
; Axis feedrate override
; Oscillation active
; Search target found
; Wait: G64 still U
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
SINUMERIK Operate (IM9)