Siemens SINUMERIK 840D sl Commissioning Manual page 316

Service and diagnostics
18.2 Displaying the Service overview
Display icon
-
#
Enable displays
From NC: On/Off1
From NC: Off2
From NC: Off 3
From the drive: Operation enabled
From the infeed: Enable operation
Pulse enable NC
Speed controller enable NC
Enable pulses
Drive ready
Heat sink temperature
Power section in i
Motor temperature
Measuring system 1 active
Measuring system 2 active
310
Meaning
Green The axis is behaving normally.
Yellow The axis is not ready.
Red An alarm is pending for this axis.
Gray The axis is not affected.
Dash No drive assigned to axis.
Special Error when reading the data, e.g. if data is not available.
characters
t limiting
2
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
SINUMERIK Operate (IM9)