Measuring Tools For Turning - Siemens SINUMERIK 840D sl Commissioning Manual

22.8.3.3

Measuring tools for turning

Measuring feedrate for tool measurement in turning operation
SD55628 $SCS_MEA_TP_FEED_MEASURE
= 300
Note
Measuring feedrate for tool measuring
All measuring cycles use the value saved in SD54636 or SD54651 as the measuring
feedrate after the tool probe has been calibrated. A different measuring feedrate can be
assigned for each calibration field [n].
When calibrating the probe, either the measuring feedrate from SD55628 is used, or the
measuring feedrate can be overwritten in the input screen when calibrating. To do this,
SD54762 $SNS_MEA_FUNCTION_MASK_TOOL bit 4 must be set to 1.
General cycle machine/setting data for measuring path/feedrate
SD42950 $SC_TOOL_LENGTH_TYP
= 0
= 2
MD51786 $MNS_J_MEA_T_PROBE_MEASURE_DIST
= 10
SD55628 $SCS_MEA_TP_FEED_MEASURE
= 300
SINUMERIK Operate (IM9)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
Default value
Measuring turning tools, type 5xx (default value)
Measuring turning tools, type 5xx, drilling and milling tools, type 1xx, 2xx
Default value
Default value
Configuring cycles
22.8 Measuring cycles and functions
Calibrate measuring feedrate for
tool probe and tool measurement
with stationary spindle.
Assignment of the tool length offset
independent of tool type.
Measuring path to calibrate the
probe or for measurements with
stationary spindle.
Feedrate for the calibration of a tool
probe with stationary spindle.
547