Setting The Ip Address Of The Ncu - Siemens SINUMERIK 840D sl Commissioning Manual

Interactive installation versions
setup.exe
setup.exe /v"BASEONLY=1"
setup.exe /v"BASEONLY=1 HELPFILES=0"
Silent installation versions
setup.exe /v"/qn"
setup.exe /s /v"/qn"
setup.exe /v"/qn BASEONLY=1"
setup.exe /s /v"/qn BASEONLY=1"
setup.exe /v"/qn BASEONLY=1 HELPFILE
S=0"
setup.exe /s /v"/qn BASEONLY=1 HELPF
ILES=0"
Additional parameter assignments
Installation path
If you install the PC version of SINUMERIK Operate, then you can additionally specify the
installation path:
setup.exe /s /v"/qn INSTALLDIR=C:\Programme\testdir"
For spaces in the path:
setup.exe /s /v"/qn INSTALLDIR=\"C:\Program Files\testdir\""
Exit code
You can identify a successful installation or errors based on the exit code of the setup.exe
call:
Exit code == 0
Exit code <> 0
Log file
During the installation you can generate a log file with
setup.exe /s /v"/qb! /L*vx log.txt"
24.3

Setting the IP address of the NCU

From the user interface of the SINUMERIK Operate, you can set the IP address of the NCU
with which it should connect.
SINUMERIK Operate (IM9)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
SINUMERIK Operate on PC/PCU
24.3 Setting the IP address of the NCU
Complete installation in the interactive mode
Base installation in the interactive mode with help
files
Base installation in the interactive mode without
help files
Complete installation in the silent mode
( suppresses all of the setup messages)
/s
Base installation in the silent mode with help files
( suppresses all of the setup messages)
/s
Base installation in the silent mode without help
files
( suppresses all of the setup messages)
/s
No error
Error
:
/L
591