Siemens SINUMERIK 840D sl Commissioning Manual page 470

Configuring cycles
22.4 Milling
Bit 2
Bit 3
Bit 4
Bit 5
Bit 6
SD55214 $SCS_FUNCTION_MASK_MILL_SET
Bit 0
Bit 2
Contour milling (CYCLE63)
SD55460 $SCS_MILL_CONT_INITIAL_RAD_FIN
= 0
> 0
Multiple edge (CYCLE79), circular position pattern (HOLES2), circumferential groove (SLOT2)
SD55230 $SCS_CIRCLE_RAPID_FEED
= 10000
464
reserved
Enable machining inside/outside
Enable spindle clamping (C axis)
Enable spindle control of the tool spindle via user interface
Enable spindle control of the lathe spindle via user interface
Basic setting, milling in climbing.
Depth calculation of the milling cycles, with or without safety clearance.
= 0 Depth calculation of the milling cycles is performed between the reference plane + safety
clearance and the depth.
= 1 Depth calculation is performed without including the safety clearance.
Bit 2 is effective in the following milling cycles: CYCLE61, CYCLE71, CYCLE76, CYCLE77,
CYCLE79, CYCLE899, LONGHOLE, SLOT1, SLOT2, POCKET3, POCKET4.
The radius is selected so that at the starting point the safety clearance to the finishing
allowance is maintained (default value).
The radius is selected so that at the starting point the value of this channel-specific setting
data to the finishing allowance is maintained.
Milling function screen
Finishing approach circle radius
The radius of the approach circle during
the finishing of contour pockets is affected.
Rapid feed in mm/min for positioning on a circular
path between the circumferential grooves or the
contour elements.
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
SINUMERIK Operate (IM9)