Siemens SINUMERIK 840D sl Commissioning Manual page 1071

3. Make the required settings here:
4. To start the restore process and entirely replace the existing data on the SSD with the
Result
The restore process is started.
Note
Troubleshooting if reading in of the disk image fails
If data transfer is interrupted during the restore process, the PCU will have no executable
system.
In this case, use a bootable USB flash drive with Service Center to read the disk image in
again.
PCU Base Software (IM10)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
Section Settings
Base Source file
parameters
Destination disk Select the SSD to be restored from the disk image.
Base Connect share
parameters >
Destination
disk
Select source
Optional Adjust
parameters partitions
disk image, confirm the settings with "Restore."
Purpose
Select the disk image from which the SSD is to be restored.
You can use local disk images or disk images stored in the
network.
Open the "Connect a share" dialog box. (Page 66)
You can manage a shared resource (e.g. a directory in the
network), to use a disk image stored on the network to restore
the SSD.
Open the "Select source file" dialog box.
You can navigate through a local directory on the PCU 50.5
and select a disk image for restoration.
Select partition scheme to be used on restoration of the data
medium image:
If the PCU Base Software Windows 7 is on the data
•
medium image, choose "PCU Base Windows 7 partition
scheme."
If the PCU Base Software Windows XP is on the data
•
medium image, choose "PCU Base Windows XP partition
scheme."
Backing up and restoring data
5.7 Restoring a disk image
69