Measuring Without Electronic Probe In Jog - Siemens SINUMERIK 840D sl Commissioning Manual

If the required mirroring is also to be automatically activated when programming the
TRANSMIT command, the TRANSMIT command must be replaced by a subprogram (e.g. in
the manufacturer directory):
MD10712 $MN_NC_USER_CODE_CONF_NAME_TAB[0]="TRANSMIT"
MD10712 $MN_NC_USER_CODE_CONF_NAME_TAB[1]="TRANSM"
TRANSMIT.SPF
PROC TRANSMIT(INT_NR)
F_T_REV2
TRANSM(_NR)
F_T_REV2
RET
Note
In the status display, TRANSM is now displayed instead of TRANSMIT.
22.8.3.5

Measuring without electronic probe in JOG

Measure workpiece
For manual measuring functions in the JOG operating mode, for which a rotating spindle is
required, the following applies:
● The channel state must be reset at the instant in time that the measured value is
● The spindle can be moved or positioned either using the T,S,M menu or using the bits in
● The following preconditions apply when using the DB3x.DBB30 technology functions with
Setting the machine data
MD10709 $MN_PROG_SD_POWERON_INIT_TAB [0] = 0
MD35035 $MA_SPIND_FUNCTION_MASK
SD43200 $SA_SPIND_S
Note
The entry in SD43200 $SA_SPIND_S is kept at power on.
With these settings, the spindle velocity for manual operation, which is set in SD41200
$SN_JOG_SPIND_SET_VELO, is no longer effective.
SINUMERIK Operate (IM9)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
transferred.
DB3x.DBB30.
fixed speed:
22.8 Measuring cycles and functions
setting data to be initialized
Bit 4=0 Spindle functions
Bit 5=1
Speed setting value
Configuring cycles
549