Siemens SINUMERIK 840D sl Commissioning Manual page 547

MD51758 $MNS_J_MEA_COLL_MONIT_POS_FEED
= 1000
MD51770 $MNS_J_MEA_CAL_RING_DIAM[n]
= -1
MD51772 $MNS_J_MEA_CAL_HEIGHT_FEEDAX[n]
= -99999
General cycle setting data
SD54780 $SNS_J_MEA_FUNCTION_MASK_PIECE
= 512
Bit 2 = 1
Bit 3 = 1
Bit 6 = 1
Bit 7 = 1
Bit 8 = 1
Bit 9 = 1
SINUMERIK Operate (IM9)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
Default value
Default value
Default value
Default value
Activates measurements with an electronic probe.
Selects the probe calibration data, enable.
Selects ZO offset in the basis reference (SETFRAME), enable.
Selects ZO offset in the channel-specific basic frame, enable.
Selects ZO offset in the global basic frame, enable.
Selects ZO offset in adjustable frames, enable.
Configuring cycles
22.8 Measuring cycles and functions
Position feedrate in mm/min, in the infeed
axis for active collision monitoring.
Pre-assignment of the calibration diameter
in mm specifically for the calibration data
sets.
Pre-assignment of the calibration height
in mm, in the infeed axis, specific for the
calibration data sets.
Configuration of the input screens for
measuring in the "Machine" operating
area in the JOG operating mode.
541