Installing The Over Pressure Limiter On Wall - ABB IRB 6640 Foundry Prime Product Manual

2.7.11.1 Installing the over pressure limiter on wall

General
ABB recommends the over pressure unit to be placed away from the robot,
preferably attached on a nearby located wall to minimize exposure to water and
detergent. Direct contact to water or detergent shall be avoided as it will decrease
the lifetime of the over pressure limiter unit.
Location of the over pressure limiter unit
xx1700001149
Required equipment
Equipment, etc.
Over pressure unit
Standard toolkit
Product manual - IRB 6640 Foundry Prime
3HAC040586-001 Revision: N
CAUTION
Always cut the paint with a knife and grind the paint edge when disassembling
parts. See Cut the paint or surface on the robot before replacing parts on page
© Copyright 2011-2018 ABB. All rights reserved.
2 Installation and commissioning
2.7.11.1 Installing the over pressure limiter on wall
Article number Note
For spare part
number see:
• Spare
parts on
page 487
- Content is defined in section
tools on page
Standard
465.
219.
Continues on next page
99