ABB IRB 6640 Foundry Prime Product Manual page 383

Preparation of the tilthouse before fitting a new motor
Use this procedure for the preparation of the tilthouse before fitting a new motor.
1
2
Preparation of motor axis 6 before fitting
Use this procedure for the preparation of a new motor axis 6.
1
Product manual - IRB 6640 Foundry Prime
3HAC040586-001 Revision: N
Action
Clean the machined surfaces inside the
tilthouse as described in the figure.
Apply Loctite 574 on the machined surface
for motor flange previously cleaned.
Action
Only applicable if a new spare part is used.
Fit a new gasket on the motor by removing
the protection strip and paste it on the new
motor.
© Copyright 2011-2018 ABB. All rights reserved.
4.6.6 Replacing motor axis 6
Note
xx1000000624
Surfaces to be cleaned:
• A: at the position for the motor
flange
• B: at the position for the o-ring on
the motor
• C: at the position for the gasket.
See A in the figure above!
For article number see:
• Additional equipment - Foundry
Prime on page 380
Note
For article number see:
• Required parts on page 379
xx1000000625
Part:
• A: Gasket
Continues on next page
4 Repair
Continued
383