Installing The Over Pressure Limiter Unit On Robot Base - ABB IRB 6640 Foundry Prime Product Manual

2 Installation and commissioning

2.7.11.2 Installing the over pressure limiter unit on robot base

2.7.11.2 Installing the over pressure limiter unit on robot base
General
ABB recommends the over pressure unit to be placed away from the robot,
preferably attached on a nearby located wall to minimize exposure to water and
detergent. Direct contact to water or detergent shall be avoided as it will decrease
the lifetime of the over pressure limiter unit. For more information see
the over pressure limiter on wall on page
Location of the over pressure limiter unit
xx1700001821
Required equipment
Equipment, etc.
Over pressure unit
Standard toolkit
Continues on next page
102
Note
An extra warning label is supplied with the robot and must be applied on the
robot base if the over pressure unit is installed on the robot base.
© Copyright 2011-2018 ABB. All rights reserved.
99.
Article number Note
For spare part
number see:
• Spare
parts on
page 487
- Content is defined in section
tools on page
Product manual - IRB 6640 Foundry Prime
Installing
Standard
465.
3HAC040586-001 Revision: N