ABB IRB 6640 Foundry Prime Product Manual page 143

4
5
6
7
8
9
10
Product manual - IRB 6640 Foundry Prime
3HAC040586-001 Revision: N
Action
Make sure that the oil temperature is +25°C
±10°C.
Remove the oil plug, filling and inspection.
Slowly turn axis 4 until the axis-4 angle reads
+72.5° to +77.5°.
Inspect the oil level in the hole for the oil plug,
filling and inspection.
The oil should reach all the way up to the extern-
al edge of the thread for the oil plug, filling and
inspection.
Note
If needed, use a clean, narrow object, for ex-
ample an oil stick or a cable tie, to gently poke
the oil surface. This will avoid surface tension
from stopping air to enter into the gearbox.
Adjust the oil level, if required.
Refit the oil plug.
WARNING
Do not mix oil types! If wrong oil is refilled, the
gearbox must be rinsed as detailed in Technical
reference manual - Lubrication in gearboxes.
© Copyright 2011-2018 ABB. All rights reserved.
3.3.6 Inspecting the oil level in axis-6 gearbox
Note
This is a precaution to reduce the
temperature dependency of the
measurement.
xx1300002447
C
xx1400002786
A Oil plug hole
B Required oil level
C Gearbox oil
Where to find type of oil and total
amount is detailed in
amount of oil in gearboxes on
page 168.
Further information about how to fill
the oil may be found in the section
Filling, oil, axis 6 on page
Tightening torque: 24 Nm.
3 Maintenance
Continued
A
B
Type and
186.
143