Installing The Over Pressure Limiter Unit - ABB IRB 6640 Foundry Prime Product Manual

2 Installation and commissioning

2.7.11 Installing the over pressure limiter unit

2.7.11 Installing the over pressure limiter unit
General
ABB recommends the over pressure unit to be placed away from the robot,
preferably attached on a nearby located wall to minimize exposure to water and
detergent. Direct contact to water or detergent shall be avoided as it will decrease
the lifetime of the over pressure limiter unit.
For more information, see the recommended solution
limiter on wall on page 99
limiter unit on robot base on page
Continues on next page
98
Note
An extra warning label is supplied with the robot and must be applied on the
robot base if the over pressure unit is installed on the robot base.
© Copyright 2011-2018 ABB. All rights reserved.
or the alternative solution
102.
Product manual - IRB 6640 Foundry Prime
Installing the over pressure
Installing the over pressure
3HAC040586-001 Revision: N