Dell C9000 Series Reference Manual page 188

source-interface
Defaults Not configured.
Command Modes
•
•
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9 (0.0)
9.2(1.0)
8.3.19.0
8.3.12.0
8.3.11.1
8.2.1.0
8.1.1.0
7.9.1.0
7.6.1.0
7.5.1.0
(OPTIONAL) Enter the keywords /source-interface then the
interface information to include the source interface. Enter the
following keywords and slot/port or number information:
• For a Loopback interface, enter the keyword loopback
then a number from zero (0) to 16383.
• For the Null interface, enter the keyword null then 0.
• For a Port Channel interface, enter the keyword port-
channel then a number. The range is from 1 to 128.
• For Tunnel interface types, enter the keyword tunnel then
the slot/ port information. The range is from 1 to 16383.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
EXEC
EXEC Privilege
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the S4810. Added support for source-interface
for link-local IPv6 addressing.
Introduced on the Z9000.
Introduced on the E-Series ExaScale (IPv6). Increased the
number of VLANs on ExaScale to 4094 (was 2094).
Introduced on the E-Series ExaScale (IPv4).
Introduced VRF.
Introduced on the S-Series.
Introduced on the C-Series and added support for IPv6 address
on the E-Series only.
Control and Monitoring 188