Table of Contents
Advertisement
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
traffic-shape queue
Use the traffic-shape queue Interface Configuration (Ethernet, Port-channel)
mode command to configure the egress queue shaper. Use the no form of this
command to disable the shaper.
Syntax
traffic-shape queue
no traffic-shape queue
Parameters
•
queue-id—Specifies the queue number to which the shaper is assigned.
•
committed-rate—Specifies the average traffic rate (CIR) in kbits per
second (kbps). (Range: 64 kbps–maximum port speed)
committed-burst—Specifies the excess burst size (CBS) in bytes. (Range:
•
4 KB - 16 MB)
Default Configuration
The shaper is disabled.
Command Mode
Interface Configuration (Ethernet, Port-channel) mode
Example
The following example sets a shaper on gigabitethernet port 1/0/5 when the
average traffic rate exceeds 124000 kbps or the normal burst size exceeds 9600
bytes.
Console(config)#
Console(config-if)#
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 5 / 1 5 / 1 2 - F O R P R O O F O N LY
CLI\files\QoS.fm
queue-id committed-rate
queue-id
gi1/0/
interface
traffic-shape
Quality of Service (QoS) Commands
committed-burst
[
5
124000 9600
]
743
Advertisement
Table of Contents
