Dell C9000 Series Reference Manual page 198

Parameters
ipv4-address
ipv6-address
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.8(0.0)
9.7(0.0)
9.2(1.0)
9.0.2.0
9.0.0.0
8.3.19.0
8.3.12.0
8.1.1.0
7.5.1.0
E-Series
Usage Information You can configure both IPv4 and IPv6 virtual addresses simultaneously, but only one of
each. Each time this command is issued, it replaces the previously configured address
of the same family, IPv4 or IPv6. The no virtual-ip command takes an address/
prefix-length argument, so that the desired address only is removed. If you enter the no
virtual-ip command without any specified address, then both IPv4 and IPv6 virtual
addresses are removed.
Related ip address
Commands
Enter the IP address of the active management interface in a
dotted decimal format (A.B.C.D.).
Enter an IPv6 address of the active management interface, in the
x:x:x:x::x format.
NOTE:
fields of zeros.
Description
Introduced on the C9010.
Introduced on the S3048-ON and S4048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the Z9000
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the C-Series.
Original command.
— assigns a primary and secondary IP address to the interface.
The :: notation specifies successive hexadecimal
Control and Monitoring 198